Welcome to my blog. My Today’s card is for the Global Design Project Challenge #GDP250. I am very excited to take part in this Challenge. In Global Design Project every week there will be new and different Challenges. This week it’s a Sketch Challenge.
Here is my today’s card using the below Sketch. Check out the challenge and
click here to take part in it.
I used Stampin’ Up! two stamp sets Butterfly Wishes and Forever Fern Stamp set, from the New Annual Catalogue 2020. All the products which I used here are available at my online store.
Measurements in Metric:
- Base Card Smoky Slate A4 Card Stock : 27.8 cm by 10.5 cm (Cut at half on 10.5 cm on 21cm side, scored and folded at half on 14.9 cm ).
- First Layer Poppy Parade : 9.5 cm cm by 13.9 cm.
- Second Layer Flowers for every Designer series paper : 9 cm by 13.4 cm.
- Third Layer Whisper White: 8.5cm by 12.9 cm
- White Vellum- Scallop Circle Die
- Poppy Parade: 9. 7 cm by 14.1 cm ( Inside )
- Whisper White: 9. 5 cm by 13.9 cm ( Inside )
- Scrap piece of Designer series paper. ( Inside )
- Scrap piece of Basic Black to Stamp the Sentiment.
- Scrap piece of smoky slate for stamp the butterfly
Measurements in Imperial:
- Base Card Smoky Slate: 8.5 “by 11”(Cut at half on 5.5″, scored and folded at half on 4 1/4″ ).
- First Layer Poppy Parade : 4 ” by 5 1/4″.
- Second Layer Flowers for every designer series paper : 3 7/8 ” by 5 1/8 “.
- Third Layer Whisper White: 3 3/4″ by 5″
- White Vellum- Scallop Circle Die
- Poppy Parade : 4″ by 5 1/4″ ( Inside ).
- Whisper White: 3 7/8″ by 5 1/8″ ( Inside )
- Scrap piece of Designer series paper ( Inside)
- Scrap piece of Smoky slate to Stamp the Butterfly ( Inside )
- Scrap piece of Basic Black to Stamp the Sentiment ( Inside )
In Australia? Click here to Shop Online 24/7:
Melodie says
Beautiful card inside and out!
Maheswari Rajaguru says
Thank you so much Melodie for your lovely comment- Hugs Maheswari 🙂